| Author |
Topic: Cast Ally Tiller Stock |
 |
Mike806 |
Posted: 19-Apr-06 11:47 |
|
|
|
(From Boss Sailor) I need the cast alluminium tiller end, is it something I am going to have to get direct from topper? I dont need the rudder stock, just the small section at the end of the tiller.
Any ideas welcome you can reply to mikeyb82@googlemail.com
Thanks |
| |
|
Ian Moss |
Posted: 19-Apr-06 12:26 |
|
|
|
The alluminium parts are sold seperately which at least make it a 'bit' cheaper than buying the whole stock. The tiller arm and top stock are often impossible to part once connected so you may have to buy a tiller arm too. It is a topper specific part which most chandleries should be able to supply. Wet & Windy normally has them in stock.
I don't know if the boss one is the same as the ISO one. The Buzz one certainly is.
Ian |
| |
|
Mike Perry |
Posted: 19-Apr-06 23:04 |
|
|
|
Mike
Don't worry about separating the tiller arm from the top stock. I have had to separate them on both my ISO and Boss and did not have any problems.
The top stock is the same on both ISO and Boss; the tiller arm is similar, just that the Boss one is the shortest, next in length is the Buzz and ISO is longer of the three.
Just make sure that when you fit them together that they are secure with no play in it - otherwise highspeed downwind can get a bit exciting. |
| |
|
Mike806 |
Posted: 20-Apr-06 18:11 |
|
|
|
Thanks guys, i ordered it finally direct from topper. Thought I might as well get the thing as a whole suprised at the cost of the cast ally section tho!!!!!!!!!! i was sitting down so fainting was not a major issue!
Thanks again |
| |
